Many miners using Claymore Dual Miner are searching for a reliable way to perform a devfee stop mining and disconnect without interrupting their rig. This guide walks through the reasons you might want to pause or redirect mining, the risks involved, and clean steps to regain control of your hardware.
Below you will find a quick reference table, detailed procedures for different scenarios, and answers to common user questions to help you manage Claymore safely and efficiently.
| Action | Command / Setting | Effect | Risk Level |
|---|---|---|---|
| Stop devfee only | —stopdevfee | Pauses fees to dev wallet, continues mining locally | Medium |
| Disconnect from pool | —disconnect | Breaks connection to current Stratum endpoint | Low |
| Full stop mining | exit | Shuts down all mining activity immediately | High |
| Reboot after command | —reboot 1 | Restarts miner to apply changes and clear state | Medium |
Understanding Claymore Devfee Behavior
How Fees Are Applied
Claymore automatically deducts a small devfee from your local earnings to support development. When you issue a devfee stop mining command, the miner stops sending those funds but may remain connected to the pool until manually disconnected.
Network and Pool Reactions
Pools often treat sudden disconnects as temporary outages. If you stop devfee and disconnect without a clean exit, the pool dashboard might show your rig as offline until it detects the Stratum timeout and fully reconnects on the next cycle.
Safe Ways to Stop Devfee and Disconnect
Prepare Your Workload
Before you pause mining, make sure current shares are acknowledged and you have logged into the pool dashboard. This reduces the chance of lost credit during the transition.
Execute the Commands
Use the Claymore console to first stop the devfee with —stopdevfee, then issue —disconnect to drop the pool connection. If you want a fresh start, follow up with —reboot 1 to apply settings cleanly.
Monitoring After Disconnect
Check Pool Status
Open the pool control panel and confirm that your worker is listed and that no stale shares are being counted. Some pools delay updates, so wait a few minutes and refresh the page.
Review Local Logs
Inspect the Claymore log output for lines related to devfee stop and disconnect success messages. A clean shutdown usually shows confirmation that no further fees will be sent and the socket is closed.
Troubleshooting Common Issues
Worker Still Shows Connected
If the pool still shows your worker as connected after you run —disconnect, check for lingering background processes and restart the miner service to fully release the session.
Fees Resume After Reboot
Some configurations store devfee preferences in configuration files. Verify that your startup scripts do not include default fee parameters after you reboot the system.
Best Practices for Managing Claymore Mining Sessions
- Always issue —stopdevfee before —disconnect to avoid unexpected fee deductions.
- Monitor pool dashboards to confirm worker status after each change.
- Keep a local log backup for debugging disconnect or fee issues.
- Use controlled reboots with —reboot 1 only when necessary to apply configuration changes.
- Document your startup parameters so you can quickly restore a stable mining state.
FAQ
Reader questions
Will my unpaid shares be lost when I stop devfee and disconnect?
Unpaid shares that were already accepted by the pool remain credited to your account. Shares lost during an abrupt disconnect may be marked as stale and are typically not credited.
Can I resume mining automatically after a disconnect?
Automatic resumption depends on your startup scripts and pool settings. If you use a watchdog or scheduler, ensure it includes the correct worker credentials and does not re-enable the devfee unintentionally.
How do I confirm that devfee has fully stopped on the next run?
Check the miner log for the line that reports zero fee deduction or a devfee disabled flag. You can also compare your wallet deposit history before and after the change to verify no fees are leaving your earnings.
Is it safe to reboot immediately after issuing the disconnect command?
Waiting a few seconds after the disconnect command allows the socket to close gracefully. An immediate reboot is generally safe but may increase the risk of interrupted logging if the process is terminated too quickly.