This guide provides Harvey's PVC closet flange spacer kit instructions for reliable leveling and alignment in tight spaces. Follow these steps to achieve a balanced, code-compliant installation without repeated adjustments.
Use the summary table below to compare base dimensions, compatibility ranges, and included components at a glance before starting your installation.
| Flange Outer Diameter | Compatible Pipe Size | Adjustable Range | Included Components |
|---|---|---|---|
| 4 inch | 3 and 1/2 inch PVC | 0 to 1/2 inch vertical lift | Spacer rings, bolts, washers, nuts |
| 4 inch | 4 inch PVC | 1/4 to 3/4 inch vertical lift | Spacer rings, bolts, washers, nuts |
| 3 inch | 3 inch PVC | 0 to 1/4 inch vertical lift | Spacer rings, bolts, washers, nuts |
| 3 inch | 2 and 1/2 inch PVC | Use shims separately | Bolts, washers, nuts only |
Understanding PVC Closet Flange Spacers
Harvey's PVC closet flange spacer kit instructions focus on maintaining uniform thickness behind the flange to support proper pipe alignment. These spacers reduce stress on joints and help the finished floor height match the building slab.
Each ring in the kit is designed to fit between the flange and the subfloor, allowing precise adjustments without cutting into finished surfaces. Use the kit when the existing floor level is slightly below your target pipe height.
Preparation and Safety Steps
Before installing, turn off water supply, clear debris, and confirm that the PVC pipe and fittings are clean and dry. Wear gloves and eye protection to prevent contact with adhesives or debris.
Measure the gap between the subfloor and the bottom of the flange, then refer to the kit chart to select the correct number and thickness of spacer rings. Keep small parts away from children and ensure the work area is well ventilated.
Step-by-Step Installation Process
Follow the sequence below for a secure, leak-free result when you follow Harvey's PVC closet flange spacer kit instructions.
- Verify pipe height and mark the target level on the wall or adjacent structure.
- Select spacer rings that bring the flange surface to the marked height.
- Place the selected spacers evenly beneath the bolt holes of the flange.
- Insert bolts through the flange, washers, and nuts, then hand-tighten.
- Align the flange using a level, then torque bolts evenly to recommended values.
- Double-check pipe alignment before pressing the flange against the subfloor.
Sealing and Final Testing
After the bolts are secure, apply a manufacturer-approved primer and cement to the joint areas. Hold the flange firmly for the recommended set time to ensure a stable bond.
Allow the assembly to cure, then run a test flush with water and inspect for any movement or visible leaks. Confirm that the finished floor height matches the project specifications and building code.
FAQ
Reader questions
Can I add additional spacers beyond the kit's listed thickness?
Yes, you can stack Harvey's PVC closet flange spacer rings as needed within the manufacturer's limits, but avoid exceeding the maximum lift specified for your flange size to maintain joint integrity.
Do I need to prime the spacer rings before installing them?
Yes, apply primer to both the flange and spacer ring surfaces when using cemented joints to ensure a strong, watertight bond that remains stable under daily use.
Will using spacers affect the slope required for proper drainage?
Spacers adjust height but not pipe slope; you must still set the pipe at the required angle using shims under the entire flange or by adjusting the hanger location to preserve code-compliant drainage.
How do I remove and reinstall the flange if adjustments are needed later?
Loosen the bolts, remove the spacer rings, and inspect them for damage before reassembly. Replace any worn or compressed rings to maintain a consistent seal and proper alignment when you reinstall the flange.